Insulation Polyurea Coating XPS Foam Insulation Board

Product technical specification The P-150 is sprayed with polyurea protection material brief introduction:

 P-150 spraying polyurea protection material is a kind of two-component aromatic polyurea elastomer, generated by isocyanate component and amino compound component reaction, need professional polyurea spraying equipment construction, the product has a high crosslinking density, tough coating, and substrate adhesion, suitable for film and television props, speakers, foam sculpture decoration and protection. use: Main use of the P-150:  Film and television props, foam sculpture, fitness equipment, audio, furniture and other surface decoration and protection. characteristic: 

 No solvent, green environmental protection, fast curing 

 Excellent corrosion resistance and resistance to chemical media properties, such as acid, alkali, salt, etc 

 Excellent sealing and penetration properties, good impact resistance 

 The coating has tough, high hardness, scratch resistance and good protective effect Product Parameter: project A component B component surface Light brown liquid Color adjustable proportion (g/m³) 1.15±0.05 1.05±0.05 Viscosity (cps) @25℃ 500±200 500±200 Solid content of (%) 98.5 Mix ratio (volume ratio) 1 1 Gel time s 8 Table dry time s 20 Theoretical coating rate (table dry film thickness) The 1.2kg / ㎡ membrane is 1,000 μ m thick 2 qualification: project testing standard bear fruit Tensile Strength (Mpa) GB/T3831-2006 ≥17 elongation (%) GB/T3831-2006 ≥70 Wear resistance (750g / 500r) mg GB/T3831-2006 ≤8 Impact strength of kg · m GB/T3831-2006 ≥1.0 Hardness of Shaw D GB/T3831-2006 ≥55 Process guidance: 

1. Surface treatment: the surface to be coated must be clean and dry, to ensure no dust, no grease and other impurities. 

2. Before spraying: stir component B with a pneumatic mixer for at least 15 minutes. 

3. During spraying, use polyurea special spraying equipment for construction. 

storage condition: Storage ambient temperature: 5℃ - -35℃ Form A: 220 kg / barrel; Form B: 210 kg / barrel The shelf life of the product is from the production date and is kept unopened Group A: 9 months. Group B: 9 months Ensure that the product package is well sealed Store in a cool, ventilated environment to avoid direct sunlight. matters need attention: 

1. Before use, stir component B evenly. 

2. It is recommended to use it in a well-ventilated environment. If you have any careless contact with the skin and eyes, rinse them with clean water immediately. 

3. The construction environment temperature should be 5-35℃, relative humidity 85% and base dew point temperature 3℃ 4. During the construction process, keep clean, dry and clean, and strictly prohibit the contact with water, alcohol, acid and alkali